Firmare update HP MSA70

[denniswier-pro]

I have a old MSA70 but it still runs fine for the purpose its here for.
But i have found a website here on HPE that stated that i could update the firmware on the MSA70.

Can someone guide me trough this process?
I asume my MSA is on Firmware 2.10, while the last version is 2.28
I also just notiched that there is a Micro USB port on the front, but i havent looked at it. (is it a CLI port?)

[ Top ] → [ Smart Array P222 in slot 2 ] → [ StorageWorks MSA 70 at Port 1E : Box 1 ] → [ Enclosure SEP (HP MSA70) ] → Physical Drive Status SCSI Bus 23 (0x17) SCSIID 10 (0x0a) Block Size 0 Bytes Per Block (0x0000) Total Blocks 0 GB (0x00000000) Reserved Blocks 0x00010000 Drive Model HP MSA70 Drive Serial Number ***** Drive Firmware Revision 2.10

[ Top ] → [ Smart Array P222 in slot 2 ] → [ StorageWorks MSA 70 at Port 1E : Box 1 ] → Subcomponent Versions SEP (1) 2.10 Backplane Module (BPM) (1) 2.06, (2) 2.06, (3) 2.06, (4) 2.06 Fan Control Module (FCM) (1) 1.08, (2) 1.08 Health Monitor Module (HMM) (1) 1.10, (2) 1.10 Seven Segment LED Display (1) 0.10

[JonPaul]

@denniswier-pro 
Here are the links to the Linux and Windows update components.
Linux: https://support.hpe.com/connect/s/softwaredetails?language=en_US&softwareId=MTX_310c8259d5f749b8a1272f1500
Windows:  https://support.hpe.com/connect/s/softwaredetails?language=en_US&softwareId=MTX_f6cf2746e6e64951842a9c7280
As you indicated this hardware is very old and out of support.  While it is always a good idea to stay current on firmware, in this case you should weigh the risk of attempting a firmware update with the knowledge that there may be no parts for repair if something should go wrong.

The USB port on the front is a 'service personnel' port only.  In most cases it is disabled from the factory.

[denniswier-pro]

@JonPaul 

Good evening Jonpaul,

Thank you for the links to the firmware.
But i see that it has to be attached to an HP P2000 G3 or MSA2000 G2.
Currently i dont own one of the 2 Storage controllers, but i did found the HP SUM 9.30 from the HPE site.
I have read that the firmware also should be on this bootable ISO, so i made a bootable USB with using this guide: "HP ProLiant Firmware Maintenance CD User Guide".

This works, but the USB is freezing on this screen:

This stays when i choose "Automated mode" & "Interactive mode"
What should be the command to start this HP SUM?

# hpsum 
# ./startup
wont start the application (either 2 options)