MSA1000 CLI config guide on RP4440

[EU-Admins-UNIX]

Hi All

Is there a document out there that details how to confiigure an MSA1000 from the CLI?  I have connectivity via the RJ45Z cable, and the MSA is newly attached to an RP4440.  The MSA is visible from the OS, obviously my ultimate aim is to configure the disks and present them as PVs to HP-UX 11.31.

0/0/10                 ba                                Local PCI-X Bus Adapter (783)
0/0/10/1                  slot                           PCI Slot
0/0/10/1/0                   fc                          HP Tachyon XL2 Fibre Channel Mass Storage Adapter
0/0/10/1/0.8                    fcp                      FCP Protocol Adapter
0/0/10/1/0.8.0.124.0                                ext_bus         FCP Array Interface
0/0/10/1/0.8.0.124.0.0                                 target
0/0/10/1/0.8.0.124.0.0.0                                  ctl       COMPAQ  MSA1000
0/0/10/1/0.8.0.255.7                                ext_bus         FCP Device Interface
0/0/10/1/0.8.0.255.7.12                                target
0/0/10/1/0.8.0.255.7.12.0                                 ctl       COMPAQ  MSA1000

Regards

Tariq

P.S. This thread has been moevd from General to Storage Area Networks (SAN) (Small and Medium Business). - Hp Forum Moderator

[hvhari]

Hi,

CLI Guide is available at : http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02520779/c02520779.pdf

You could also try using the web interface (Storage Management Utlity) for configuring the storage system.

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02520791/c02520791.pdf

[hvhari · Accepted solution]

Hi,

I gave P2000 MSA G3 guides in my previous post.

Guides for MSA 1000 is below.

CLI User guide : http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01183955/c01183955.pdf

[EU-Admins-UNIX]

Thanks.  Printer, acetated and bound!

Lovely!