HPE Community
Netservers
1846430 Members
2757 Online
110256 Solutions
New Discussion

Can't connect Top Tools remote control card to network

 
Bryan Eley
Trusted Contributor

‎03-22-2005 03:23 AM

‎03-22-2005 03:23 AM

Can't connect Top Tools remote control card to network

Hi,

I have a D6028A that is installed in an LH4 netserver running Windows 2000 Advanced Server. For some reason the card doesn't appear to be able to connect to my lan. I've gone through the setup in F3 at bootup and enable a fixed IP address. For testing purposes I left the ip address and subnet at their defaults. At bootup, the card is detected, and the 10baseT connection light on the Top Tools card stays a solid green and the diagnostic led flashes green twice every 2 seconds or so. However, the jack on the hub where the card is connected to is unlit, so I cannot access it remotely. I also can't access the card locally in the browser by entering its IP address 192.168.10.10. The card is "new" but I'm wondering what the problem is.
0 Kudos
1 REPLY 1
Bryan Eley
Trusted Contributor

‎03-28-2005 12:14 AM

‎03-28-2005 12:14 AM

Re: Can't connect Top Tools remote control card to network

Never mind, I had recently discovered the hub the card was attached to was not a switched hub. Once that was remedied, the card worked as expected.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.