- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- Netservers
- >
- Trouble with Navigator on NetServer TC4100
Netservers
1753463
Members
4832
Online
108794
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-02-2002 08:39 AM
08-02-2002 08:39 AM
Trouble with Navigator on NetServer TC4100
Hi,
i am trying to set up a HP TC4100 with 3 hot swap hd 36 Gb e 3 hot swap hd 18 GB. Everything is OK (BIOS recognise them, ecc...), but when I try to launch HP NetRAID Assistant I see no phisical or logical disk. I see only the two channel. I cannot understand. Thank you! Bye
i am trying to set up a HP TC4100 with 3 hot swap hd 36 Gb e 3 hot swap hd 18 GB. Everything is OK (BIOS recognise them, ecc...), but when I try to launch HP NetRAID Assistant I see no phisical or logical disk. I see only the two channel. I cannot understand. Thank you! Bye
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-02-2002 09:06 AM
08-02-2002 09:06 AM
Re: Trouble with Navigator on NetServer TC4100
Bruno,
When you say you see your hotswap hdds in the Bios do you mean in the SCSI bios and on POST but not in NetRaid Assist? That would indicate that you are cabled to the onboard SCSI and not your NetRaid 2M.
Check your cabling and verify your config.
Ciao,
Greg
When you say you see your hotswap hdds in the Bios do you mean in the SCSI bios and on POST but not in NetRaid Assist? That would indicate that you are cabled to the onboard SCSI and not your NetRaid 2M.
Check your cabling and verify your config.
Ciao,
Greg
Lets Roll!
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP