APA

[seduarte]

Hello all,
I have 3 networking ports on my rx4440 hpux 11.11.
question 1 can I use apa on 2 ports connected to same switch and the other port as fail over connect to another switch??

question 2 can I use apa on 2 ports conneced one to one switch and another one to other switch??

thanks
sergio

[Steven E. Protter]

Shalom sergio,

That depends on what network the switch is on.

if both switches are on the same network then yes.

Both questions.

SEP

[seduarte]

Hi steven, thanks for the answer.

I do not know how to configure both, you have any tips, and what would be the best solution.

tks
sergio

[rick jones]

You should probably peruse the APA documentation. Last time I went looking it was archived on docs.hp.com.

[R.K. #]

Hello Sergio,

From docs.hp.com

For 11iv1 and v2
HP APA Configuration Examples
http://docs.hp.com/en/J4240-90046/ch03s01.html


For 11iv3
HP APA Configuration Examples
http://docs.hp.com/en/J4240-90045/ch03s01.html

Regds

[Prasanth Thomas]

Hi,

Before configure the APA please check with network team that what kind of set up are currently configured.
Please find the below document

http://docs.hp.com/en/J4240-90046/J4240-90046.pdf

Regards,
Prasanth Thomas.

[Prasanth Thomas · Accepted solution]

Hi,

I have creted one document for APA configuration and please find the attached same.

Regards,
Prasanth Thomas

[seduarte]

Thank you all for your help especially to Prasanth Thomas, that attached a good manual.

[Prasanth Thomas]

Hi Sergio,
Many Thanks for you comments. :)

Thank You.
PT.