HPE Community
Operating System - HP-UX
1828621 Members
5895 Online
109983 Solutions
New Discussion

Auto Port Aggregation Configuration

 
Sanjeev Kohli_1
Advisor

‎11-04-2002 05:50 PM

‎11-04-2002 05:50 PM

Auto Port Aggregation Configuration

I am trying to configure Auto port Aggragation on one of my servers . I have configured the card 100 Full Duplex mode .

I am using FEC_Manual do the required configuration thru SAM but after adding the lan cards to APA I am getting the following error .

Error: Protocol already logged on the port 0. Cannot add selected ports to lan101

Please help me out pleaase ..


Sanjeev

Sanjeev Kohli
0 Kudos
Reply
1 REPLY 1
Jean-Louis Phelix
Honored Contributor

‎11-04-2002 11:54 PM

‎11-04-2002 11:54 PM

Re: Auto Port Aggregation Configuration

Hi,

This sometimes can happen because some of the cards have already been configured. Once you have really finished your configuration, try a reboot and see if this message still appears.

Regards
It works for me (© Bill McNAMARA ...)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.