Changed lun size not recognized

[Tonny Sejr Kromann]

On 11iv3 I created 4 x 250GB to replace 1 x 1TB lun. But they did not provide enough PE's.
So I changed the lun's on the EVA8100 to 251GB, but it will not show more PE's. How do I make hp-ux recognize the changed lun sizes?

--
Best regards
Tonny

[Michal Kapalka (mikap) · Accepted solution]

hi,

you could use diskinfo on raw devices,

to know the size and them run ioscan -fn && insf -eC disk

and again diskinfo, to kno if the lun size was changed.

mikap

[Duncan Edmonstone]

Things don't always happen automagically...

read the technical paper here - it should make all things clear:

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01920387/c01920387.pdf (BSC link updated by admin)

HTH

Duncan

[Tonny Sejr Kromann]

Thanks for helping guys :)

--
Best regards
Tonny