HPE Community
Operating System - HP-UX
1833602 Members
3905 Online
110061 Solutions
New Discussion

Re: configuring 0mn and 1mn

 
Edgar Brito
Advisor

‎10-23-2009 05:57 PM

‎10-23-2009 05:57 PM

configuring 0mn and 1mn




My cluster is formed by two nodes, let us say node1 and node2.

When I do an Ignite with make_tape_recovery

node1 points to /dev/rmt/0mn

and

node2 points to /dev/rmt/1mn


I would like to know where can I set this parameters?
0 Kudos
Reply
1 REPLY 1
Michael Steele_2
Honored Contributor

‎10-24-2009 12:11 AM

‎10-24-2009 12:11 AM

Re: configuring 0mn and 1mn

Hi

Can I see node 1: ioscan -fnC tape
node 2: ioscan -fnc tape
-and-

cmviewcl -v
Support Fatherhood - Stop Family Law
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.