console port 1is hung on itanimun

[pedliz11]

have an itanimum server console port 1 got hung on a reboot. tried rs and reboot in the cm menu
but to no avail. Any suggestions
note ie.. cell0 is working fine.

[Torsten.]

Is this the server where you are installing vPars?
What model is it?

[pedliz11]

yes i installed the first vpar0 in cell0

[melvyn burnard]

did you include the core i/o card that has the console connected into teh Vpar?
If niot, you MUST include it for the console to work

Read the manual and consider a training course

[Torsten. · Accepted solution]

Did you try to toggle between the virtual consoles with CTRL a?

Also read this:

"When the virtual partition that owns the hardware console port is shut down, there will be
a pause of console output (the system is not hung) as console IO management switches over
from the virtual partition to the vPars Monitor. Console output resumes automatically after
the pause. You will not lose any console output. During the switchover period, no console
input is accepted."

The console port must be included in the first vPar only on PA-RISC systems.

[pedliz11]

torsten as usual you always have the right answer. You are the man... I was just about to complete the install and oops the network connection is gone... So much for a mexican datacenter. This is crazy because when i lose connections sometimes i think it something i did but ole and behold someone disconnected me.
the whole trick is to create your first vpar and use an ignite server to build your other vpars.. Of couse you must include all of your paths to the devices when you create it. Thank you very much a reward awaits you.