1833883 Members
2115 Online
110063 Solutions
New Discussion

console problem

 
SOLVED
Go to solution
SSP_1
Regular Advisor

console problem

Hi,

We have a K210 model and am installing hpux11.00 on it. First I want to know whether K210 model supports 11.00, 32 bit or not?

Additionly, while installing I am stuck up at the console prompt...machine is booting up...but i can't retrieve output on console...although I switch on/off consolee it just shows the same bottom menu of "Auto" etc. how to get rid of this menu?

pl help !!!!
Obstacles exist to challenge you to keep going. Not to quit.
6 REPLIES 6
eran maor
Honored Contributor
Solution

Re: console problem

Hi

first K-210 in support by hp-ux 11.00 .

i have this k-class in our office and i install over there 11i and also 11.00

this is for your first que.

about your second que.

check the key in the computer to see if it is on service or hold .
love computers
SSP_1
Regular Advisor

Re: console problem

eran,

the server key is in "on" mode only.
Whenever we r putting it on we r getting user interface menu direrctly so I think that this may be the problem. Eventhough I am resetting the monitor I gets user interface menu....
Obstacles exist to challenge you to keep going. Not to quit.
Bill Hassell
Honored Contributor

Re: console problem

Are you using an HP terminal such as the 700/92 or one of the newer C-series of terminals, or are you using a PC for a console? If it is an HP terminal and the menu you are referring to is a set of boxes across the bottom, these are softkeys or function keys. Most likely, someone has been playing with them and taken the terminal offline.

The steps to put the terminal into REMOTE MODE (and out of BLOCK MODE if necessary) or to change the emulation depend on the terminal you are using.


Bill Hassell, sysadmin
SSP_1
Regular Advisor

Re: console problem

Hi Bill,

Thanks a lot..atlast I am able to get into. It starts showing the booting process on the console. But the new prob is If I enter any command at "MENU" prompt say "boot P6" then it shows "Error : unknown commnad". what may be the possible reasons....any key sequence of terminal U suggest for the same?
Obstacles exist to challenge you to keep going. Not to quit.
Helen French
Honored Contributor

Re: console problem

Hi Sripad,

I have experienced the same problem. Look like you have some problems with the terminal settings. Choose the terminal emulation as "HP". If needed, select "7 bit and odd parity" or "8 bit no parity". This depend on your terminal type. You need to play around with that.

HTH,
Shiju
Life is a promise, fulfill it!
SSP_1
Regular Advisor

Re: console problem

Hi Eran,

Now we r facing a different poblem. We are able to install hpux11.00 os on HPK210 model server. I want to add a disk of 36 GB capacity to the server for additional work load. It's a scsi disk. If I connect it to the scsi port of k210, my k210 server doesn't boot at all. After removing the disk it behaves well. I checked for scsi id conflict but there seems tobe no problem. Have you ever connected an additional scsi disk to k210 server?

pl reply asap.
Obstacles exist to challenge you to keep going. Not to quit.