D370 will not boot

[Jun Zhang_4]

After turning on the power, the led will show test messages until it stop at

init C44A
AP console CPU0

the console monitor doesn't have anything shown. In case of boot up normal, the led should have D370 and something else shown up.
This machine has been running fine, no known changes.

Jun

[Eugeny Brychkov · Accepted solution]

It should be C440. Your terminal is not in remote mode. Please press F4 and asterisk should appear in remote mode area at the bottom or completely reset terminal - power it off, press and hold 'd' key, turn on terminal and wait for beep. Then release 'd' key and press enter by its request. Then server will continue to load
Eugeny