DTC 16RX Manager

[Jamie Willard_2]

Can someone tell me if the DTC 16RX Manager is supported on 11.23? If not, how do I control DTC 16RX's?

[Torsten.]

Hi,

the documentation says HP-UX 9.0x or later, see

http://docs.fc.hp.com/en/netcom.html#DTC

[Jamie Willard_2]

I see that, it say's "Using the HP DTC 16RX Manager HP-UX 11i v1, 11i v2 [ PDF ]" When you actually open the PDF link, the manual describes 9.x and 10.x, but not 11.x. I do have it successfully installed on 11.11 from the application CD's however.
Now I need to install it on a rx6600 running 11.23.

The application DVD's don't show J2496A or B, nor does the DVD_TABLE_OF_CONTENTS from any of the discs contain the word DTC.

[Andrew Rutter · Accepted solution]

Hi jamie,

If i remember correctly Hp dropped the dtc's out of the 11.23 version.

These docs also state no support for the dtc manager software also.

http://docs.hp.com/en/5990-8153/ch02s06.html

http://www.hp.com/softwarereleases/releases-media2/latest/december_2006/ssm200612.htm

You could try and install the 11.i v1 software? not supported but may work? not sure how well though.
Dtc's are getting old now and this should be accounted for in upgrading systems.

Otherwise its just run 11.i version 1, depends upon hardware though, itanium/pa-risc

Andy

[Jamie Willard_2]

Thank you Andrew,
I am attempting to install the 11iV1 version now. I will post my results shortly.

[Jamie Willard_2]

J2496B DTC 16RX Manager A.14.3J.110 is so far successfully running on an rx6600 running HPUX 11.23.
I installed it off of the 11.11 application CD.
CD Part Number - 5012-7838
4 of 4 CDs

Thanks again for your ideas!

[Andrew Rutter]

Jamie,

Thanks for posting your findings, its good to know and may help others too



Andy

[Jamie Willard_2]

Thanks