HPE Community
Operating System - HP-UX
1827293 Members
3412 Online
109717 Solutions
New Discussion

DTC 16TN

 
Jeff Laux
Occasional Advisor

‎10-27-2000 06:47 AM

‎10-27-2000 06:47 AM

DTC 16TN

I am wanting to upgrade firmware on my DTC 16TNs to make them DTC 16RXs. I am told that my TNs must be at least A.00.01.005 in order to upgrade to RX. Does anyone know the command that will tell me the current firmware revision of my DTC 16TNs?

I tried using dtcdiag -s. It has a Revision Code section. Is it the Self test code or the upld/dwld code that I need to look at to determine if I am able to upgrade it to a RX?

Thanks,
Jim
0 Kudos
1 REPLY 1
Patrick Wessel
Honored Contributor

‎10-27-2000 06:54 AM

‎10-27-2000 06:54 AM

Re: DTC 16TN

One way (I'm not sure if this is the only one) is to connect a Terminal to the diagnostics port and reset the DTC. After completing the selftest does the firmware version appear in the upper right corner of the screen
There is no good troubleshooting with bad data
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.