Dynamic symbol table for kernel fails to load on boot

[Eddie Mace]

HP-UX 11.23 rx8640

After applying Dec2007 patch bundle I get the following WARNING Messages (Have rebuilt kernel, and still get the same warning messages). Any ideas? Thanks for the help.

:

Found adjacent data tr. Growing size. 0x345e000 -> 0x745e000.
Pinned PDK malloc pool: base: 0xe000000100ba2000 size=119160K
WARNING: kernel symbol table is not available.
DLKM will be disabled, but the system
will continue to boot.
Loaded ACPI revision 2.0 tables.
MMIO on this platform supports Write Coalescing.

MFS is defined: base= 0xe000000100ba2000 size= 1944 KB
WARNING: init_kern_symtab: Dynamic symbol table for kernel is not constructed appropriately.
No symbolic information will be available, hence the loadable
module mechanism will not work.

WARNING: mod_init_phase1: init_kern_symtab returns other than 0.

[Laurent Menase]

are you sure you didn't install any 11.31 module?

[Dennis Handly]

How much memory do you have?
It is probably time to contact the Response Center.

[Eddie Mace]

Thanks for the reply.

The existing loadable modules have been installed since June 2007, and have gone through several reboots without any issues.

This issue 1st occurred after applying Dec 2007 patch bundle, and I would have thought that swinstall would have caught any version mismatchs(???).

[Eddie Mace]

Memory is 31.9gb. Have since contacted Support Services.

Thanks for the answers.

[Laurent Menase]

do you have any product taken from software.hp.com like ots?

[Eddie Mace]

No OTS. Currently in communication with Support Center, so will assign points and close this thread. Thanks for the answers.

[Eddie Mace]

No quick answer to this question. Currently in Contact with Support Center, so will not waste the Forums time any further on this issue.