HPE Community
Operating System - HP-UX
1836624 Members
1857 Online
110102 Solutions
New Discussion

Re: Fibre channel question

 
Filosofo
Regular Advisor

‎01-14-2004 12:31 AM

‎01-14-2004 12:31 AM

Fibre channel question

Hello,
I have a FC whare 3 days ago we have take away the link (cable), and now if I execute fcmsutil /dev/td3 i see:
Previous Topology = PTTOPT_FABRIC
Link Speed = UNINITIALIZED

I would like change Previous Topology from PTTOPT_FABRIC to UNINITIALIZED.
I try to reset, disable and enable the adapther....
What can I do....



Thanks

Filo
Sistem engeneer expert
0 Kudos
Reply
2 REPLIES 2
T. M. Louah
Esteemed Contributor

‎01-14-2004 12:47 AM

‎01-14-2004 12:47 AM

Re: Fibre channel question

Make sure that nothing is attached to it and then reset it and take it offline with fcmsutil. It will probably change to "Awaiting Link up".

T+
Little learning is dangerous!
0 Kudos
Reply
Filosofo
Regular Advisor

‎01-14-2004 12:57 AM

‎01-14-2004 12:57 AM

Re: Fibre channel question

I'm sure.....
Driver state = AWAITING_LINK_UP
fcmsutil /dev/td3 get remote all
No device found.

Please help

Thanks

Filo
Sistem engeneer expert
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.