HPE Community
Operating System - HP-UX
1833776 Members
2317 Online
110063 Solutions
New Discussion

Re: Graphic Monitor bad...How to reset to use serial.

 
SOLVED
Go to solution
Joseph C. Denman
Honored Contributor

‎02-21-2002 02:07 PM

‎02-21-2002 02:07 PM

Graphic Monitor bad...How to reset to use serial.

Need a little help.

K570 running 11.0
graphics monitor went bad
I can telnet to the system
I want to attach a serial monitor to reload some software.

How do I get the system to switch to the serial interface for the console???

Thanks,

Joe...
If I had only read the instructions first??
0 Kudos
Reply
2 REPLIES 2
S.K. Chan
Honored Contributor

‎02-21-2002 02:29 PM

‎02-21-2002 02:29 PM

Solution

Re: Graphic Monitor bad...How to reset to use serial.

I think you need to shutdown the system, disconnect the keyboard from the Core I/O first, then connect your serial console to the console connector on the Core I/O. Then power up.

Reply
Joseph C. Denman
Honored Contributor

‎02-21-2002 03:09 PM

‎02-21-2002 03:09 PM

Re: Graphic Monitor bad...How to reset to use serial.

YOU DA MAN!!!!

Just had to cycle the power.


Joe...
If I had only read the instructions first??
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.