How can I make serial port 1 console?

[Jun Zhang_4]

I configured tty0p0 as the terminal device and got the login prompt. Then I detached the graphical monitor. During reboot, after the message,
io_search failed
there is nothing go to my serial port terminal until the J5000 boot up 11.00, then the login prompt show up at the terminal.
From the system led, it still says console is graphic7.


Jun

[Karthik S S · Accepted solution]

Hi,

1. Turn the systemâ s power off.
2. Disconnect the USB keyboard connector from the system rear panel.
3. Connect a serial terminal to the serial connector 1 on the system rear
panel. The serial parameters are: 9600 baud, 8 data bits, no stop bits.
4. Power on the system.
The system will now display the console to the terminal connected to
Serial 1 port.

For more details refer to page no:153 of the below PDF,

http://h20000.www2.hp.com/bizsupport/CoreRedirect.jsp?targetPage=http%3A%2F%2Fh200001.www2.hp.com%2Fbc%2Fdocs%2Fsupport%2FSupportManual%2Flpv37676%2Flpv37676.pdf

-Karthik

[Jun Zhang_4]

I feel the authority of the information. I'll test it a little later, though.

Jun