HPE Community
Operating System - HP-UX
1846983 Members
3519 Online
110257 Solutions
New Discussion

How to start the JCI with SGeSAP

 
Jyotindra Patel
Occasional Contributor

‎12-04-2009 11:40 AM

‎12-04-2009 11:40 AM

How to start the JCI with SGeSAP

How do I get the JCI up and running with SGeSAP (version 5.00)? I have configured sap.config for SCS as follows and starts up.

JDBSID=SPZ
JDBADM=oraspz
JCINAME=SCS
JCINR=06
JCIRELOC=192.1.162.101

A manual start JCI using the following works.

su - spzadm -c "startsap j2ee JC07 dpspz728"

So where/what do I configure for JCI to start up using SGeSAP?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.