1833875 Members
2779 Online
110063 Solutions
New Discussion

Ignite Restoration

 
Mohan Chander
New Member

Ignite Restoration

I have restored the Ignite backup of HP rp 5470 server on HP rp 4440 server. After the restoration is over the server is thrwoing the foolowing error message while booting. Can ony one suggest what could be the issue
8 REPLIES 8
Michael Steele_2
Honored Contributor

Re: Ignite Restoration

Let's clarify where you are: Is the system up at run level 3?

who -r

What does 'lvlnboot -v' report?

Can you get a dump from the command line?

savecrash -rf /dir/crash (* any dir. about 2gb in size *)

Support Fatherhood - Stop Family Law
Michael Steele_2
Honored Contributor

Re: Ignite Restoration

Let's clarify where you are: Is the system up at run level 3?

who -r

What does 'lvlnboot -v' report?

Can you get a dump from the command line?

savecrash -rf /dir/crash (* any dir. about 2gb in size *)

Looks like you have no swap so you'll have to verify the primary disk for booting up. You'll never get a bootup if there's not lvol1 2, or three not present or if they're not contiguous.

Think about reinstalling.

Support Fatherhood - Stop Family Law
Mohan Chander
New Member

Re: Ignite Restoration

well after bch. when the server is booting from the hard disk at that time it is throwing the error message that i have sent to you.
Michael Steele_2
Honored Contributor

Re: Ignite Restoration

Reinstall. Interrupt the automatic restore to manually configure the install. Don't use the auto restore. Manually select your primary disk, manually enter your ip, gateway, NIS, timezone, etc.
Support Fatherhood - Stop Family Law
Mohan Chander
New Member

Re: Ignite Restoration

we had tried the intractive installtion only.

DCE
Honored Contributor

Re: Ignite Restoration

Mohan,

Did you go under additional options on the basic screen? there is an option there - clone to different hardware - that needs to be set to true.

Michael Steele_2
Honored Contributor

Re: Ignite Restoration

Also verify your ignite tape.
Support Fatherhood - Stop Family Law
Torsten.
Acclaimed Contributor

Re: Ignite Restoration

Even this message is shown on every panic, this time it could be the reason due to the big difference in the hardware:

"NEED DRIVERS ?????"

What version you are running on the rp5470?
The 2 system are really different in the hardware layout, you it may be impossible to clone a rp5470 to a rp4440.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!