Installation errors for HPUX 11.11

[Robert Loureiro]

I am trying to install the latest copy of 11.11 using ignite-ux. I receive the following errors:

* Aborting the Install Phase.

ERROR: Software load had one or more errors.

WARNING: Will continue and verify that key filesets have been loaded.

ERROR: Software "SW-DIST.SD-CMDS" was not found on host "loopback:/".

ERROR: Software "SW-DIST.SD-AGENT" was not found on host

ERROR: Software "SystemAdmin.OBAM-RUN" was not found on host

ERROR: Software "LVM.LVM-RUN" was not found on host "loopback:/".

ERROR: Software "LVM.LVM-KRN" was not found on host "loopback:/".

ERROR: Software "JFS.VXFS-BASE-KRN" was not found on host

ERROR: Software "JFS.VXFS-BASE-RUN" was not found on host

WARNING: Because some key filesets were found to be missing, you must now retry

the software load process to load them.



======= 10/20/08 14:12:30 EST The operating system software has not been

successfully loaded. The swinstall(1M) application was not completed

or failed to load some key files. (exit status was = 1).



1: Change the swinstall server and/or depot information.

2: Retry software load process (non-interactive mode).

3: Retry software load process (interactive mode).

4: Run a shell.

Choose a recovery action from above:

----------------------------------


This is similar to the errors that someone found about a year ago and had also posted here. I did not see any resolution to the problem.

I have mounted the media on a DVDrom.

Regards, Rob

[Tim Nelson]

What version of Ignite ?

Did you configure the host with IP and hostname on a working NIC ?

[Robert Loureiro]

I do not know the version of ignite. It was on the 11.11 DVD disk. As for the IP, I have not configured that yet. Should the IP address be correctly configured before the ignite installation?

- Rob

[V. Nyga]

Hi,

at which hardware do you want to install?
How have you created ignite?
How do you want to install it, tape - network (ignite server)?

Volkmar

[Robert Loureiro]

Hello,

I am installing 11.11 on a K360, using the version of ignite that is on the DVD. Since I am in the middle of the installation, I cannot eject the DVD to verify the version of ignite. This is a local installation (no network).

Regards, Rob

[V. Nyga]

Hi again,

if it's a new installation, is it necessary to use ignite?
Can you install quite from the media?

BTW - which thread did you find about this?
Can you post that link, too?

V

[Robert Loureiro]

Here is the link to the thread that I mentioned earlier that had a similar problem with the installation:

http://forums11.itrc.hp.com/service/forums/questionanswer.do?admit=109447626+1224792435988+28353475&threadId=1179558


Regards, Rob