HPE Community
Operating System - HP-UX
1833832 Members
1935 Online
110063 Solutions
New Discussion

IPV6 to IPv4

 
geetasri
Occasional Contributor

‎05-14-2008 07:58 PM

‎05-14-2008 07:58 PM

IPV6 to IPv4

Hi all,

How to configure IPV6 in HP-UX11iV3 when the network & router are all IPV4.

Thanks,
J
0 Kudos
Reply
3 REPLIES 3
Torsten.
Acclaimed Contributor

‎05-14-2008 09:31 PM

‎05-14-2008 09:31 PM

Re: IPV6 to IPv4

I don't understand the sense in doing this, if the server is the only device using this protocol ... please elaborate.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
rick jones
Honored Contributor

‎05-15-2008 09:19 AM

‎05-15-2008 09:19 AM

Re: IPV6 to IPv4

If yhou have a remote IPv6 system to which you want IPv6 connectivity, you will need to setup a tunnel over IPv4. Might try man -k tun and or man tun and perhaps a perusal of the 11.31 (11i v3) manuals at docs.hp.com for how to setup an IPv6 over IPv4 tunnel - I am assuming that HP-UX 11iv3 knows how to do such a thing.
there is no rest for the wicked yet the virtuous have no pillows
0 Kudos
Reply
geetasri
Occasional Contributor

‎05-30-2008 12:03 AM

‎05-30-2008 12:03 AM

Re: IPV6 to IPv4

I wanted to Install IPV6 on stand alone server to test our application. Like I wanted to Install this IPv6 in 2 HP boxes which are in the same subnet.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.