Itanium with HP-UX.

[Cleber Zorzi]

Hello,

I have one server Itanium (RX1620) with 4GB memory RAM and HP-UX installed, but the operational system only recognizes 2GB memory RAM. As I make so that the operational system recognizes 4GB memory ?

Thanks,

Cleber

[Kent Ostby · Accepted solution]

Did the system come from the factory with the 4 GB installed or did you add memory/install memory yourself.

[Steven E. Protter]

Shalom Cleber,

swapinfo -tam

Please post.

Use cstm to show memory layout.

SEP

[Arunvijai_4]

Hello,

# swapinfo -tam ??

-Arun

[Cleber Zorzi]

SEP,

I don´t swap memory.

Cleber

[Sandman!]

Hi Cleber,

Could you post your memory configuration using cstm; this will output the memory inventory on your system...

# echo "selclass qualifier memory;info;wait;infolog" | cstm

[Steven E. Protter]

If you post the output of swapinfo -tam it will show total memory and virtual memory.

I'm on the idea that you may be misreading the situation on memory recognition.

The cstm output would be helpful as well.

Good Luck,

SEP

[Andrew Rutter]

hi,

You can also check with SAM how much physical memory you ahve installed under system properties.

better to post output from
echo "selclass qualifier memory;info;wait;infolog ¦ cstm > /tmp/memlog.txt

If the memory is there then it should be available for use.

Andy