Solved: Re: kmtune and SAM Kernel tuning

Bill McNAMARA_1 · ‎06-20-2001

Hi,
using kmtune to update standard kernel parameters, ninode, nproc..
kmtune -s works to change and kmtune -l -q reports the change as taken, but sam still recognises the older value.. even after recompilation and reboot.

How do I tune the kernel from command line..
am I missing something?

Later,
Bill

It works for me (tm)

eran maor · ‎06-20-2001

Hi Bill

Sam is getting the information from /usr/conf/master.d/*

i will try to check this dir for the params .

love computers

Vincenzo Restuccia · ‎06-20-2001

#sysdef

Carsten Krege · ‎06-20-2001

You probably missed to run

# kmupdate

after kernel build. This is automatically done if you shutdown instead of reboot.

Carsten

-------------------------------------------------------------------------------------------------
In the beginning the Universe was created. This has made a lot of people very angry and been widely regarded as a bad move. -- HhGttG

Kandaswamy Natarajan · ‎06-21-2001

I second carsten, after the changes to kernel update the old with new.
mk_kernel
kmupdate
shutdown -r -y now

Now check the parameters

Strive for perfection

Bill McNAMARA_1 · ‎07-06-2001

Yes y'all that's what it was..
If I can remember correctly I needed to do a kminstall just before the kmupdate..
in either case thanks for the help.

Later
Bill

It works for me (tm)