1830906 Members
2507 Online
110017 Solutions
New Discussion

lanadmin command problem

 
Uday_S_Ankolekar
Honored Contributor

Re: lanadmin command problem

Hello,

Use aut-neg off at both the ends ( server and switch port.) Also check if switch port is configured for 100Mbps.
Most of the time it is switch port is configured at lower speed and you face this problem

lanadmin -X 100FD 0 should set speed for you then.

-Goodluck,
-USA..
Good Luck..
MQ'ski
Regular Advisor

Re: lanadmin command problem

I will try again with auto negtiation off