LVM config after re-loading from IGNITE tape

[Jack Kalbach]

I attempted to re-load a system with an IGNITE tape to a new disk array (Model 20 to a Model 20). I used the same paths, set the scsi ID's ...

Booted off the ignite tape and loaded root to a mirror group ...
It seems that I have messed up the lvmtab ..

output of "strings lvmtab "
strings lvmtab
/dev/vg00
/dev/dsk/c3t5d0
/dev/vg01
/dev/dsk/c3t5d1

does not match Ioscn output
ioscan -fnC disk
Class I H/W Path Driver S/W State H/W Type Description
==============================================================
disk 0 32.5.0 disc3 CLAIMED DEVICE DGC C2300WDR10
dev/floppy/c3t5d0 /dev/rfloppy/c3t5d0
disk 1 32.5.1 disc3 CLAIMED DEVICE DGC C2300WDR5
dev/floppy/c3t5d1 /dev/rfloppy/c3t5d1
disk 2 52.2.0 disc3 CLAIMED DEVICE TOSHIBA CD-ROM XM-3301TA
/dev/dsk/c4t2d0 /dev/rdsk/c4t2d0
/dev/floppy/c4t2d0 /dev/rfloppy/c4t2d0
disk 3 52.6.0 disc3 CLAIMED DEVICE HP C2247M1
/dev/floppy/c4t6d0 /dev/rfloppy/c4t6d0


the disks were are /dev/dsk/c3t5d0 and /dev/dsk/c3t5d1, ioscan shows :
/dev/floppy/c3t5d0 and /dev/floppy/c3t5d1 ..

Any ideas on how to correct this ?? or should I start over ??

Thanks

[Sandip Ghosh · Accepted solution]

do an insf -e to create the device files for the disks.

[Corthouts Carlo]

Hi,

Strange.....

Is this an 11.00 system?

The floppy and rfloppy are normal but you should also have the dsk and rdsk.

What you could do is run "insf -e" which recreates all the device files.
That should fix the situation for you.

[Jack Kalbach]

thank you

insf -e rebuilt the device files ...

I was able to mount the other lvols ..

Thanks Much