MAKE RTECOVERY ON FILE

[Federico_28]

Dear all, I'd like to do a make_recovery but out tape i broken and I can't change it. Is it possible to do a make recovery on file and then put it on another system and then on it's tape? Or is it possible ti do a make_recovery from another system via network? Thank you
regards
Federico

[Robert-Jan Goossens]

Hi Frederico,

I've got a feeling you are using a old version of Ignite, the make_recovery has been replaced by the make_tape_recovery command.

There are two other Ignite commands you could use.

Make_sys_image > will create a sysem image on the local disk.

Make_net_recovery > will create an image to an Ignite server.

Best regards,
Robert-Jan
Ps.
http://h20392.www2.hp.com/portal/swdepot/displayProductInfo.do?productNumber=IGNITEUXB

[Mike Shilladay]

Hi Federico,

You need to use the make_net_recovery command, that will make an ignite image and send it to a server that you specify. As I do not know your configuration I would suggest that you read the manual for the command so as you can customise to your liking.

A link to the latest manual (edition 28) is here:

http://www.docs.hp.com/en/5992-0602/5992-0602.pdf

An example of the command might look like this:

make_net_recovery -s -a : -d

[Robert-Jan Goossens]

add on,

Hav a look at the created by John Meissner in this thread. Search in the thread for make_sys_image.

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=51050