olrad command giving errors

[dictum9]

This is on an Itanium xz6000 running 11.23.
How can I enable this command?

#: olrad -q
Error : Capability not implemented; Could not obtain information of all slots

[Torsten. · Accepted solution]

Hi, the zx6000 (similar to rx2600) is NOT olar-able.

This command cannot run on this hardware.

[dictum9]

Where can it run? Is there a similar command that can run on it?

[Torsten.]

What info do you need?

[dictum9]

I sometimes have difficulty correlating which lan0 lan3, lan2, etc. maps to which card.

[Torsten.]

From the manual:

Slot Path Description
1 AGP Acpi(HWP0003,400)/pci(0|0) Slot 1:0/4 (upper rack slot)
2 PCI Acpi(HWP0002,300)/pci(1|0) Slot 2:0/3
3 PCI Acpi(HWP0002,200)/pci(1|0) Slot 3:0/2
4 PCI Acpi(HWP0002,600)/pci(1|0) Slot 4:0/5 (lower rack slot)



Drive Path Description
SCSI disk Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun0,Lun0) 0/1/1/0.0.0 (lower disk)
SCSI disk Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun1,Lun0) 0/1/1/0.1.0 (middle disk)
SCSI disk Acpi(HWP0002,100)/Pci(1|1)/Scsi(Pun2,Lun0) 0/1/1/1.2.0 (upper disk)
Removable
media boot
Acpi(HWP0002,0)/Pci(2|0)/Ata(Primary,Master

[Torsten.]

page 3-13
http://docs.hp.com/en/5969-3163/5969-3163.pdf