1834079 Members
2357 Online
110063 Solutions
New Discussion

olrad command

 
SOLVED
Go to solution
Feljav
Frequent Advisor

olrad command

When I use the olrad -q command I get the following error:

Error : Capability not implemented; Could not obtain information of all slots
What can i do?
5 REPLIES 5
Torsten.
Acclaimed Contributor
Solution

Re: olrad command

Hi,

what type of server?
Please run "model" and post.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Feljav
Frequent Advisor

Re: olrad command

ia64 hp server rx1620
and
9000/800/rp3440#1
Both servers have hpux 11.23
Torsten.
Acclaimed Contributor

Re: olrad command

Both servers does not support on-line addition and replacement of I/O cards.

Normal behaviour.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Feljav
Frequent Advisor

Re: olrad command

Thank you very much!
Torsten.
Acclaimed Contributor

Re: olrad command

You are welcome.

Please take some time and read this:

http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!