PCI NIC card is not shown in the SAM

[Barbara Kingston_1]

I just purchased a PCI 10/100Base-TX/9000 from HP. I installed it on an HP B132L running HPUX 10.20. When I go into SAM I only see the on-board NIC card. The instructions say to install the software using the Source Depot. It says to highlight J4253AA (for servers) or B5509BA (for workstations) I did not recieve any software with the card. Does anyone know where I can get the software?

Thank you, Barbara Kingston

[A. Clay Stephenson · Accepted solution]

The network card software is almost always on Disk 1 of any Application Software Set.

[Sajid_1]

Hi,

You have to install this software from the first Application CD. This will be on the CD set which you got from HP.

hth,

[Hai Nguyen_1]

Barbara,

After you have loaded the LAN J4235AA sw. You may want to install the latest patch for it at the following link:

http://support2.itrc.hp.com/service/patch/patchDetail.do?patchid=PHNE_25580&context=hpux:800:11:00

Hai

[???_72]

Hi Barbara

I'm experiencing the same situation. Did you fix the problem? If so, where did you get the software? If you already have it, would you please send me (jjlee@aidcorp.com) a copy?

Thanks in advance.
Good day!

Jaeju Lee
AID Corp.