printing problem on hpjl2200

[Stefano_10]

I have a problem printing on a hplaserjet2200:
i have configured this printer using jetdirect.
Now when i print on this printer the document is printed many times without ends.
The job is always pending.
It seems that the printer doesn't send the message that the document is been pritend, or the server doesn't receive it.
I have verify all network setups and they are all correct.
What can i check or modify to solve this problem?
Thanks
Stefano

[Geoff Wild]

For the multiple copies, check the printer and see what "Copies=" is set to....

How did you add the printer to your system?

We do this for Jet Direct:

addqueue -i 9998 -q LP1 -h lp1.domain.com

Rgds...Geoff

[Steve Steel · Accepted solution]

Hi


use the hppi or jetdirect software to set teoj

true end of job off.


The spooler is needing too long to get a reply and the card is sending data again.see below

Then the spooler will check and not the JD card



Enter the lp destination name (q - quit): belgo138

Modifiable Queue Parameters
-----------------------------
Settings may be changed by selecting the corresponding numbers. You
can make as many changes as you want until '0' is selected.
To abort the operation, press 'q'.

Warning: Modifying a queue while printing a job may cause the job to
be cancelled and re-started again.


Options: Current Settings:
-------- -----------------
1) Default Queue [YES]
2) Status Log [OFF]
3) Additional printer changes . . .

Modelscript used for this queue is net_lj4x

Select an item for change, or '0' to make the changes effective (q - quit): 3

Modifiable Printer Parameters
-----------------------------
Settings may be changed by selecting the corresponding numbers. You
can make as many changes as you want until 'q' is selected.


Options: Current Settings:
-------- -----------------
1) Job Recovery [ON]
2) True End-of-Job [OFF]
3) Banner Page [ON]
4) Default Printing Language [AUTO]
5) PostScript Level [Level 1]

Select an item for change, or q when done:


steve Steel