HPE Community
Operating System - HP-UX
1836611 Members
2002 Online
110102 Solutions
New Discussion

pvchange -p on 11.31

 
michael averkorn
Occasional Advisor

‎05-26-2008 10:06 PM

‎05-26-2008 10:06 PM

pvchange -p on 11.31

Hello,
i use pvchange -p on 11.11. now i installed 11.31 and i miss it ! whitch patch or what new command i have to use ???

Thanks
Michael
0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎05-26-2008 10:29 PM

‎05-26-2008 10:29 PM

Re: pvchange -p on 11.31

Due to the new native multipathing many things are changed. You may control multipathig with "scsimgr" - see the man page.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
michael averkorn
Occasional Advisor

‎05-26-2008 10:54 PM

‎05-26-2008 10:54 PM

Re: pvchange -p on 11.31

I read this :
The following LVM features are new with the September 2007 release of HP-UX 11i v3:
Proactive Polling of Alternate Links: A new command line option, -p, has been added to the pvchange command. This option controls the way LVM monitors alternate links to a multi-pathed physical volume.

By default, LVM proactively monitors the health of all configured links. If autoswitchback is enabled (the default), this polling helps LVM detect and switch to a better link when it becomes available.

If proactive polling of alternate links is undesirable, polling can be disabled using pvchange -p n.
I do not see this feature in 11.31 :-((
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.