HPE Community
Operating System - HP-UX
1839899 Members
3953 Online
110156 Solutions
New Discussion

Re: Questions about Ignite-boot!

 
ekke2
Occasional Advisor

‎03-05-2006 01:11 AM

‎03-05-2006 01:11 AM

Questions about Ignite-boot!

When I boot from an Ignite Tape and the boot is done, can I connect the server via telnet.
What i mean, is the service on, when the boot is done.
0 Kudos
Reply
3 REPLIES 3
f. halili
Trusted Contributor

‎03-06-2006 02:22 AM

‎03-06-2006 02:22 AM

Re: Questions about Ignite-boot!

no. you are booting in single user mode.
derekh
0 Kudos
Reply
Steven E. Protter
Exalted Contributor

‎03-06-2006 03:30 AM

‎03-06-2006 03:30 AM

Re: Questions about Ignite-boot!

Shalom,

You need to complete the Ignite restore process before the machine can come up in multi user mode.

The machine will be accessible only via the console during the restore process.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
0 Kudos
Reply
Jov
Honored Contributor

‎03-07-2006 04:41 PM

‎03-07-2006 04:41 PM

Re: Questions about Ignite-boot!

Hi,

During a system rebuild from ignite, the system will reboot at least once, then will bring the server back to multi-user mode. Only then you can connect again.

If you're after a remote session to monitor the process, I suggest you configure your GSP to allow remote access or usr a Web Console.


Jov
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.