HPE Community
Operating System - HP-UX
1850405 Members
2615 Online
104054 Solutions
New Discussion

restricted sam

 
Eugene Klaus
Frequent Advisor

‎07-11-2004 01:03 AM

‎07-11-2004 01:03 AM

restricted sam

I entered this question before and came to no good resolution. I thought I would try again.
I have used sam -r to set up a user with sam
privelege. On one system w/hpux 10.20 all is well. On the second system w/hpux 11.00, one user setup find and works well. All other attempts to setup user with sam privelege fail.
I have promises to keep and miles to go before I sleep and miles to go before I sleep
0 Kudos
Reply
3 REPLIES 3
Geoff Wild
Honored Contributor

‎07-11-2004 03:23 AM

‎07-11-2004 03:23 AM

Re: restricted sam

Just a stab in the dark - try deleting the user, then re-adding, then readding command to restricted SAM.

Rgds...Geoff
Proverbs 3:5,6 Trust in the Lord with all your heart and lean not on your own understanding; in all your ways acknowledge him, and he will make all your paths straight.
0 Kudos
Reply
Shaikh Imran
Honored Contributor

‎07-11-2004 06:01 PM

‎07-11-2004 06:01 PM

Re: restricted sam

Hi,

Just check if your problem resembles this

http://www2.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000073730429

Regards,

I'll sleep when i am dead.
0 Kudos
Reply
Eugene Klaus
Frequent Advisor

‎07-12-2004 11:44 PM

‎07-12-2004 11:44 PM

Re: restricted sam

I haven't had the opportunity to apply patches in hopes of correcting my problem. However, I appreciate the responses and have applied points in anticipation of success.

Thanks Again!
I have promises to keep and miles to go before I sleep and miles to go before I sleep
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.