rp7410 adding a cell to a existing active partition

[Vijaya Kumar_3]

hi
I have a RP7410 with two cells with single partition. I am new to this and had some literature. Here is the status from parstatus.
[Cell]

cab0,cell0 inactive 4/0/4 8.0/ 0.0 cab0,bay0,chassis0 yes - -
cab0,cell1 active core 4/0/4 8.0/ 0.0 cab0,bay0,chassis1 yes yes 0


I am right now using cell 1 and i want to add cell 0 to the current partition.
i am going to use these commands
# parmodify -p 0 -a cell0
# shutdown -R

anything else need to be done? i want to make sure before doing this and i am looking for more of ur expert guidance
Thanks in advance
Vijay

[Hemanth Gurunath Basrur]

Hello Vijay,

Please refer to the following links:

http://forums1.itrc.hp.com/service/forums/parseCurl.do?CURL=%2Fcm%2FQuestionAnswer%2F1%2C%2C0xcff1e822e739d711abdc0090277a778c%2C00.html&admit=716493758+1066274619161+28353475

http://forums1.itrc.hp.com/service/forums/parseCurl.do?CURL=%2Fcm%2FQuestionAnswer%2F1%2C%2C0xbbf2b33befae194baaded91462fb0d11%2C00.html&admit=716493758+1066274577879+28353475

http://forums1.itrc.hp.com/service/forums/parseCurl.do?CURL=%2Fcm%2FQuestionAnswer%2F1%2C%2C0x927f227a6ab4d711900a0090279cd0f9%2C00.html

Hope this helps.

Regards,
Hemanth

[Bhuvaneswari Selvaraj · Accepted solution]

Hi,

Absolutely correct... You can do it.

After you assign a cell to an nPartition, or remove an active cell from an nPartition, you can perform a reboot for reconfig of the
nPartition to complete the cell addition or removal.

Make sure you type 'R' and not 'r' option for the shutdown command.

Your cell will not have any clm and will have all the memory as interleaved memory. If you want to change the same, specify the -clm option or else waht you have sp[ecified looks great.

[Vijaya Kumar_3]

Thanks selva for your review.
you are great!

Here is the online book:
http://docs.hp.com/hpux/onlinedocs/5187-3603/00/00/1-con.html

-Vijay