rx2600 Monitoring Port

[Ralf Buchhold]

Hello
I have a problem. My console on a rx2600 doesnt work. Can I use the monitoring port
from HPUX ?
Perhaps to set the IP adress to the monitoring card.
After the setting the IP adress I can toggle between console and monitoring port.
Thanks
Ralf

[RAC_1]

Did you reset the GSP?? From command prompt you can reset it as follows.

stty +resetGSP /dev/diag1 (device file name of GSP)

Anil

[Ralf Buchhold]

Sorry
I onla have diag2
But why should i reset the port?
Can I set / read the port messages
with /dev/diag1 or /dev/diag2 ?
Thanks
Ralf

[donne007]

Hi
Answering your Quetion..

Resetting the GSP is the way if your Console is hung.. As RAC has suggested.
I guess the monitoring stuff you ar etalking is a virtual One which Invokes from the Diagnostic subsystem ( EMS.. )

Are you talking abt configuring the MP( Management Processor) lan Console? .. yes you can..

The BMC( BAse management Contl) is the HP engg to diagnoise.
The "console" serial port - it's the top connector, and it's labelled "console"


Good luck
Asif