rx6600 - cannot lanboot

[Eric Herr]

Created an image of this rx6600 using make_net_recovery. Trying to dump this image back to the same rx6600 server to resize the root filesystem. I'm getting the following message trying to use "lanboot select" and selecting the ip address. This adapter works fine when the server is booted.

Client MAC Address: ...
PXE-E12: Could not detect network connection. Check cable.
Exit status code: Invalid Parameter

[Sameer_Nirmal]

The error message indicates that the lan interface card selected by lanboot select is not UP and no network cable is connected.

Select the correct interface card which is on the same subnet as that of IG-UX server and it should work.

[Eric Herr]

The problem was that I created the ignite image when logged into the iLO console.