HPE Community
Operating System - HP-UX
1825987 Members
3640 Online
109690 Solutions
New Discussion

Re: Setting SCSI interfaces for the SC10

 
SOLVED
Go to solution
Gerhard Hannemann
Occasional Advisor

‎08-15-2000 09:39 PM

‎08-15-2000 09:39 PM

Setting SCSI interfaces for the SC10

More on the SC10. Each SC10 has 2 BCC each connected to a separate SCSI card. The idea is should one scsi path fail the other should take over. These scsi card are set in the PDC. Do these scsi card (who sole purpose is to serve the SC10) have the same ID (which is usually set to 7) or should they have different ID's such as the primary card is 7 and the secondary card is 6.

Thanks Gerhard
I'll make it work
0 Kudos
Reply
2 REPLIES 2
Patrick Wessel
Honored Contributor

‎08-15-2000 11:02 PM

‎08-15-2000 11:02 PM

Solution

Re: Setting SCSI interfaces for the SC10

Defiantly on different SCSI Ids (6 & 7)! If you don't operate the SC10 in split-bus mode are both BCCs on the same bus and both SCSI Host Bus Adapters as well.
There is no good troubleshooting with bad data
Reply
Gerhard Hannemann
Occasional Advisor

‎08-16-2000 04:46 PM

‎08-16-2000 04:46 PM

Re: Setting SCSI interfaces for the SC10

Thanks this make perfect sense. I think I need to know more about how this works !

Gerhard
I'll make it work
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.