Table is full

[Valkiria Santos]

Hi guys,

I??d like to know wath kernel parameter I need set to message vmunix: kthread: table is full.
Nproc? Ninod? Nfile? other one? I??ve oracle 8i anda Sybase 12 in the same machine.
My o.s is 11.11.

Thanks,
Valkiria

Thanks

[Pete Randall · Accepted solution]

Valkiria,

Do you have Glance installed? If so, you can check the system tables report and it should point you to the right parameter.

Pete

[Bill McNAMARA_1]

nkthread

post up the results of sysdef.

Later,
Bill

[Valkiria Santos]

avail used %used
nproc -276 123 45
nfile- 920 511 56

This is my values, how much you recomend to add, 30%, 50%?
In 11.11 version, this parameters reboot the system?

[Valkiria Santos]

Look sysdef output.

[Pete Randall]

Valkiria,

They're pretty low. Not really knowing anything about your system I would say you could easily double them. Using SAM to increase maxusers should accomplish this since maxusers is used in the formulas for both these parameters.

HTH,
Pete

[Trond Haugen]

You would want to increase the parameter 'nkthread'.

Regards,
Trond

[Valkiria Santos]

Tony,

I not found this parameter.
Valkiria

[Pete Randall]

Very good, Trond. I didn't connect kthread with nkthread. Using SAM to increase maxusers will also bump up nkthread thanks to the formulas.

Pete