Terminal

[Mohd Syafid Abdullah]

Hi Guru,

I want to install HPUX 11 on my HP Visualize B1000. However, the display connector that connect from monitor cable cable to display card is missing.
I don't know how to connect the monitor.
Can i install the os from the dumb terminal?
Please guide me..

TQ

[Deepak Kulkarni]

Hi

Connect to the console port through the hyper terminal. And you can install.

Regards
D K

[Devender Khatana]

Hi,

On a workstation it is not possible if you have not console port if you have console port you can. But you can connect any normal monitor to your workstation if it has a 15 Pin D-type female VGA port & then by changing resolution setting you can use that monitor.

HTH,
Devender

[Mohd Syafid Abdullah]

Hi Guru,

On my HP Visualize have 2 serial port?
Is that port that u mean?

[Jannik]

On a B1000 server you have serial 1 and 2 connect your old terminal to serial 1 and install the workstation as you would a server.
To be able to use you grafical interfase ether bye a grafical card for B1000 or install remote consoles like VNC.

[Mohd Syafid Abdullah]

i still confuse.Is it I need to use the console cable that connect to parallel port on my server or i can connect the terminal direct to my serial 1@2 port?

I've try to connect to port 1 @ 2 but there is no command promp after i press enter or off/on back the terminal?

Please help

[Devender Khatana]

Hi,

You can use normal serial console cable (Not parallel) to connect this to a serial port of a PC/Laptop. There will not be a prompt untill machine boots so power recycle the machine and then wait for something to come on terminal. Also check that terminal is a working one.

HTH,
Devender

[Jannik]

If you have a old serial console connect that to serial 1.
Else use you laptop...

[Mohd Syafid Abdullah]

Im using HP Dumb Terminal.But it still no output at the dumb terminal monitor..
Please help me..

[Stephen Keane · Accepted solution]

When you reboot, disconnect the keyboard, then the workstation will default to the serial port. You can reconnect the keyboard when you have some output on your dumb terminal.

[Mohd Syafid Abdullah]

Hi Stephen,
Thanks for your reply.
It really help.

TQ