Ultrium 460 and hpux 11.i

[David_550]

Hi,
Somebody can help me with this error message in my hpux 11.i:

Informational: Raw Text
OC_Exception_c caught: I/O Exception (Error: 2123 - I/O: Device is busy and unable to respond)Press any key to continue

The december Gold path was installed and when i acces to my tape (ultrium 460) the message is present.

What is the problem??
Thanks

[Steven E. Protter]

ioscan -fnC tape

Look for a problem NO_HW and such.

Best thing to do is check the hardware is plugged in, etc and scsi is terminated and then restart the system.

if you can't do that, consider insf -e followed by ioscan -fnC tape

Also make sure the tape drive isn't write protected.

SEP

[David_550]

Hi Steven,
Following is the problem:
I have two tapes ultrium 460,
I need update the firmware of one of my ultrium 460 tape with the hp_ltt program, i update the december 2003 Gold path before.
When i execute ioscan -funC Tape , the tapes are claimed, but when i access to the ultrium 460 with the hp_ltt program for begin the actualization, this software present the following error messages:

OC_Exception_c caught: I/O Exception (Error: 2123 - I/O: Device is busy and unable to respond)

This only happen with one tape.

What is the problem?

[Kurt Beyers.]

Is the tape claimed as well when you perform a 'ioscan -fnC tape'?

best regards,
Kurt

[Animesh Chakraborty]

Hi,
Can you install PHKL_29248 (stape patch)and try?

Thanks
Animesh

[Shaikh Imran]

Hi,
Please try the upgrade of the Firmware through XSTM.
For this you have to either copy the firmware update file to a filesystem and refer the path when asked for.

Regards,