HPE Community
Operating System - HP-UX
1836644 Members
1656 Online
110102 Solutions
New Discussion

V-class boot path change

 
SOLVED
Go to solution
Rich Wright
Trusted Contributor

‎07-01-2002 02:28 AM

‎07-01-2002 02:28 AM

V-class boot path change

After teststation firmware update, the primary boot path was wrong. I did a "sea" and "boot p1". Then I realized that I had not altered my boot paths to be correct. How can I set them on the running server?
0 Kudos
Reply
2 REPLIES 2
T G Manikandan
Honored Contributor

‎07-01-2002 02:37 AM

‎07-01-2002 02:37 AM

Solution

Re: V-class boot path change

Hello,
use setboot for that

look at man pages setboot
set the boot path and enable autoboot

#setboot -p 8/4.0.0 -b on
Reply
T G Manikandan
Honored Contributor

‎07-01-2002 02:38 AM

‎07-01-2002 02:38 AM

Re: V-class boot path change

ALso check this document

http://support1.itrc.hp.com/service/cki/docDisplay.do?docId=200000024719102
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.