Web console

[Patrick Chim]

Hi,

My server runs HP-UX 11.0. I cannot connect to the web console and see the green light on right hand side flashing all the time. So I reset the power but it still fail. How can I connect it again ?

Many thanks,
Patrick

[Dayanand Naik]

Hi Patrick,

Did u change yr web console ip address to the network address your server is on, if not do it and then you can use a browser and http to it. eg: http://10.10.10.10

From the web browser u can reset the webconsole and do a more lot of activity.

hope that helps.

Regards,
Dayanand Naik.

[Ravi_8]

Hi,
If the green LED flashes all the time, shows that network is ok..
which IP u r using toconnect to webconsole, by default web console will be having 192.0.0.192
If you are connecting the second one then you need to change the ip of the first web console say like 192.0.0.193/194....
If still you are not able to connect to web console, then reset the web console.

[cxtwo]

have you tried resetting while holding down the webconsole button? Hold down the button, and put in the power plug - this will reset the console IP to 192.0.0.192

hth

[Andreas D. Skjervold · Accepted solution]

Hi
Here is from my previous posting:

On your client (workstation/pc/laptop) connected to the same subnet:
1. route add 192.0.0.192
2. ping 192.0.0.192
if not succeed:
3. arp -s 192.0.0.192
then ping should succeed
4. Access console through web browser and follow the instructions that appears.

If you mess it up and want to start over you can reset the webconsole by powering off by pulling out power cable, then keep pressing the button while powering on and keep the button pressed a couple of seconds.

See also: http://www.hp.com/go/webconsole

Good luck!

[Matjaz Obstetar]

Hi Patrick

Do you have connected console and the web console at the same time? If you have, try to unplug the console from your system and then try to connect to your system via web console.

Matjaz