HPE Community
Operating System - HP-UX
1833758 Members
2407 Online
110063 Solutions
New Discussion

Re: why display SCAN when i ioscan the disk

 
SOLVED
Go to solution
Rambo_1
Regular Advisor

‎03-21-2006 06:52 PM

‎03-21-2006 06:52 PM

why display SCAN when i ioscan the disk

Hi, everybady
When I #ioscan -fnCdisk ,I found the displayed of the result were "SCAN" status with these disk . and then I ioscan these disk again ,I found the status were "CLAIMED" . I don't know why? the array is va7400 .

Thanks for your help.

B.R

Rambo

0 Kudos
Reply
2 REPLIES 2
RAC_1
Honored Contributor

‎03-21-2006 06:58 PM

‎03-21-2006 06:58 PM

Solution

Re: why display SCAN when i ioscan the disk

The man page says, when status is SCAN the node is locked.

SCAN node locked, try again later

What anything else being done on system or on VA7400 at that point in time?
There is no substitute to HARDWORK
Reply
Torsten.
Acclaimed Contributor

‎03-21-2006 11:54 PM

‎03-21-2006 11:54 PM

Re: why display SCAN when i ioscan the disk

Another ioscan process is running. Either a user run this tool or the system diagnostic. Really not unusual - don't worry.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.