make_tape_recovery

[Randy_9]

I've got 2 systems running 10.20, when I run
"make_tape_covery -i" on one it pops into the
character based utility, on the other I get:
*****************************************
Do you want to proceed in setting your TERM value and running
mnr_ui? (yes or no) [yes]

Input the correct value for your terminal or press "return" to set
the default TERM value = hp. TERM = (hp)
******************************************'
I am using EXCEED from a PC and the TERM type
is "dtterm", it works on the other one, here
no matter what I try (hpterm, vt100, dtterm)
it all fails and I had to just bomb out. Any
ideas?.

Thanks,

Randy

[Kodjo Agbenu · Accepted solution]

Hello Randy,

Just a little remark : this is a forum dedicated to Linux.

About your problem, I would suggest :

-> Make sure you are connecting from Exceed to both servers with the same Exceed configuration.

-> Compare /etc/profile, /.profile, your_home_directory/.profile, /.dtprofile, your_home_directory/.dtprofile on both servers. Look at lines that set the default terminal.

Good luck.

Kodjo

[Randy_9]

Thanks for the info, I gotta get my queues
straight!

Randy