minicom problem

[chinna_1]

hi
i have two serial port in which one is connected to mouse other i want for minicom,
but my problem are
1.when i run minicom my mouse gets hanged(nit working)
2.through serial communication (minicom) i m not able to communicate not even junk messages is printing ,i have set the baud rate correctly also.
hope u all have understood my problem

[Sergejs Svitnevs]

Make sure that your COM ports are on different IRQs (COM1-IRQ4,COM2-IRQ3).

Sounds like minicom is trying to write to your mouse. Does your minicom use the correct COM port?

Regards

[chinna_1]

thanks for the reply
this is my booting message for com1 and com2
ttyS0 at 0x03f8 (irq = 4) is a 16550A
ttyS1 at 0x02f8 (irq = 3) is a 16550A

[Sergejs Svitnevs]

please run "minicom -s" to set initialization parameters:

Serial port setup -> Serial device:/dev/ttyS1

Regards

[chinna_1]

my mouse is using ttyS1
so i given ttyS0 then also no result
but i m connecting only minicom (removing mouse port) it is coming ,but desktop panel is not in control

[Alexander Chuzhoy]

I suggest you to switch ports:
move the mouse to first serial port and plug the cable into second serial port.
then you'll have to reconfigure the minicom to use the correct port (ttyS1).
Let us know if it helps.

[chinna_1]

there are two ports consists of 9 pins and 21 pins .
my mouse port consist of (9 pins) and minicom port is (21 pins or 9 pins)
how should i connect mouse port(9pins) in 21 pins port.

[chinna_1]

sorry it is 25 pins and 9 pins ,instead of 21 pins and 9 pins

[chinna_1]

thanks for replies
actually there was problem with my motherboard port