HPE Community
Operating System - Linux
1838374 Members
3253 Online
110125 Solutions
New Discussion

ProLiant ML110 G6 ADDRCONF(NETDEV_UP): eth0: link is not ready

 
Testaccio Labello
New Member

‎10-23-2010 06:49 AM

‎10-23-2010 06:49 AM

ProLiant ML110 G6 ADDRCONF(NETDEV_UP): eth0: link is not ready

Hello Everybody, i use slack linux at my proliant server, but the os cant connect net beacouse eth0 dont can make a '(dmesg | grep eth )link up'...

HOWTO make it ON?!

Thanks all... :-|
0 Kudos
Reply
3 REPLIES 3
Alan_152
Honored Contributor

‎10-25-2010 07:12 AM

‎10-25-2010 07:12 AM

Re: ProLiant ML110 G6 ADDRCONF(NETDEV_UP): eth0: link is not ready

What happens when you use the command "ifconfig eth0 up"?
0 Kudos
Reply
Testaccio Labello
New Member

‎10-26-2010 06:30 AM

‎10-26-2010 06:30 AM

Re: ProLiant ML110 G6 ADDRCONF(NETDEV_UP): eth0: link is not ready

at 'ifconfig eth0 up' don't happens nothing and i can't ping net... 'ping: unknown host www.host.com'

it's possible who 'tigon3' need specially parameters at load module time?
0 Kudos
Reply
Alan_152
Honored Contributor

‎10-26-2010 06:33 AM

‎10-26-2010 06:33 AM

Re: ProLiant ML110 G6 ADDRCONF(NETDEV_UP): eth0: link is not ready

Please reply with the version of Slackware, the kernel revision, and the network card type being discussed.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.