Route default gateway not configured after reboot

[carodn]

Hello, I have a problem with a Vpar in a rx-8620 system, with HP-UX B.11.23 U ia64 operating System, when I reboot the Vpar and the system is ready, after 5 minutes, the route of the default gateway disappear, I lost the remote connections and I have to configure through the console, when the route is restored, the system continue working normally. This incident happens every reboot on this Vpar and it doesn't happen with the others, which have the same settings.
If anyone could help me I really appreciate that.
Thanks a lot,
Regards, Carolina.

[Karl Rohwedder]

Carolina,

this is the OpenVMS forum. I suggest,you ask your question in the HP-UX forum.

regards Kalle

[carodn]

I'm sorry
regards, Carolina

[Peter Zeiszler]

Actually check if you have a startup job changing your route or reseting something in the IP configuration (like something that is suppose to just check IP but actually changes instead). That could account for it working for 5 min then it going away. Could also be cron job but less likely.

[carodn]

I resolved the problem, the solution is in this thread:
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1076985

Thanks for your collaboration
Regards, Caro