HPE Community
Operating System - Tru64 Unix
1826421 Members
3608 Online
109692 Solutions
New Discussion

Re: Can't see floppy device booting from Tru64 5.1a CD

 
mjp7
New Member

‎09-28-2006 02:31 AM

‎09-28-2006 02:31 AM

Can't see floppy device booting from Tru64 5.1a CD

Hopefully this is an easy one. I had to replace the system disk on a DS10 running Tru64 5.1a. I've booted from the OS CD after replacing the disk with a new one and now I can't mount or see the floppy drive.

I can see it at the chevron prompt and I see the controller with the hwmgr -sh component command, but I don't see the drive with the hwmgr -sh dev comand.

I have tried doing a dn_setup -boot, but had no luck.

Any help would be greatly appreciated, thanks.
0 Kudos
1 REPLY 1
mjp7
New Member

‎09-28-2006 06:06 AM

‎09-28-2006 06:06 AM

Re: Can't see floppy device booting from Tru64 5.1a CD

Turns out there was a hardware problem with the floppy drive. We could see and access the floppy once the bad drive was replaced.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.