fail to find hard when install ds20

[陳文賢]

Sir :

When I install Tru64 5.1B O.S . It didn't find hard disk . but I can find the hard in the console. My environment is below :
1.ds10
2.arrary card --> KZPAC-XF

Who can help me ?

[Venkatesh BL]

what is the output of '>>> sh dev' ?

[陳文賢]

Sir :

dra0.0.0.0.15.0 dra0 1 member JBOD

but I cann't find it when install Tru64 5.1B

[Venkatesh BL]

How do you say that you can't find the hard disk during installation?. Are you saying it because of the absence of 'dra0' in the disk list?. If so, note that 'dra0' will be mapped to a device file name typically., 'dsk' (eg: dsk0)

[陳文賢]

sir :

I can see it in console , but error message show " fail no hard disk " and exit when boot dqa0(cdrom) install Tru64 5.1B .

[IT Response]

Some Configuration notes.
The KZPAC only supports disks up to 9GB.

The KZPAC-XF may only be supported on a range of systems made by Digital Equipment that used Windows NT below



CT-CC871-AA [A01] DS5305,
CT-DELTA-AA [A01] RM7300
CT-DELTA-AB [A01] RM7300
CT-FUNB2-01 [A01] DS7310
CT-JSANS-AA [A01] DS7305




Brian

[Holger Nieraad]

Hello,
find this article:

-------------------------------------------
Situation
-----------
System Type: AlphaServer800 & AlphaServer1200
O/S Version: 5.0 & 5.0A

O/S's are not seeing the KZPAC's disks.

Analysis
----------
These 2 servers are internal use machines. The FE is trying to install 5.0
& 5.0A to work with the product. He has tried installing on both the AS800
and AS1200 with the same result - O/S CD is not seeing the disks. He gets
an error when the Xserver comes up that there are no disks to install on.
He can boot the 4.X CD and it sees the disks fine. There are seen fine from
the console. If he uses the disks as JBODs - then they seen. Problem occurs
if the disks are in a RAID or Mirror set. He is suppose to be at the latest
firmware for both system and controller.

Resolution
-----------
Found that the latest firmware for the controller was 2.70 and e-mailed the
link to the FE:
http://sawhorse.cxo.dec.com/STORAGE/SCSI/ADAPTERS/DEC/KZPAC/index.html

Had him use the SWXCR utility and disable the fault management as per BLITZ
[TD 2800-CR] Functionality Loss in KZPAC RAID W/Fault Management Off

After doing this and booting the 5.0A O/S CD, it was able to see the
3-member RAID-5 set.

--------------------------------------------

More Infos + Firmware Files/update-Utility(RA200-utility) you can find under:

http://h18006.www1.hp.com/alphaserver/products/storage/retired/ra230/index.html

-Holger-

[Ivan Ferreira]

You may need to install the operating system with New Hardware Delivery added at installation time. Check the New Hardware Delivery documentation for information about how to do that.