Install TZ89 in a 4100 with Tru64 4.0G

[HDgio]

Hi
I have two 4100 with 4.0G and TZ89.
in console mode with "show dev" i see:
mkc100 TZ89.
when boot with the command scu scan edt, i can't see a TZ.
Why? need a driver? How I can install it ?
Thanks to all

[Vladimir Fabecic · Accepted solution]

Hello
Does scu see anything on bus 2 address 1?
Did you connect TZ89 to newly installed controller or to existing one (hope you have no address conflict)?
Anyway, you can try to boot generic kernel:
>>> boot -file genvmunix
and see if something changed.
If you installed a new controller with tape device, you must boot with genvmunix and rebuild the kernel with doconfig.
Regards

[HDgio]

It's OK
Thanks

[HDgio]

I have found a solution to this question